4D Doc Center : SAVE RECORD

Home

4D v14.3

SAVE RECORD


SAVE RECORD {( aTable )}

Parameter	Type	Description
aTable	Table	Table for which to save the current record, or Default table, if omitted

Description

SAVE RECORD saves the current record of aTable in the current process. If there is no current record, then SAVE RECORD is ignored.

You use SAVE RECORD to save a record that you created or modified with code. A record that has been modified and validated by the user in a form does not need to be saved with SAVE RECORD. A record that has been modified by the user in a form, but has been canceled, can still be saved with SAVE RECORD.

If you call the SAVE RECORD command when no field has been modified in the record, the command does nothing (the trigger is not called).

Here are some cases where SAVE RECORD is required:

To save a new record created with CREATE RECORD or DUPLICATE RECORD
To save data from RECEIVE RECORD
To save a record modified by a method
To save a record that contains new or modified subrecord data following an ADD SUBRECORD, CREATE SUBRECORD, or MODIFY SUBRECORD command
During data entry to save the displayed record before using a command that changes the current record
During data entry to save the current record

You should not execute a SAVE RECORD during the On Validate event for a form that has been accepted. If you do, the record will be saved twice.

Example

The following example is part of a method that reads records from a document. The code segment receives a record, and then, if it is received properly, saves it:

 RECEIVE RECORD([Customers]) ` Receive record from disk

 If(OK=1) ` If the record is received properly…

    SAVE RECORD([Customers]) ` save it

 End if