4D Write v15
Referring to Characters
Referring to Characters
A character in a document is referred to by its sequential number. Commands that refer to characters enable you to specify either a single character or a range of characters. For example, you can specify a word, a sentence, or whole blocks of text to be selected.
You use the WR GET SELECTION command to determine the positions of selected characters in a 4D Write area. The command uses the $First and $Last parameters to refer to the range of selected characters. The $First parameter is always one less than the first character selected. The $Last parameter is equal to the last character selected.
For example, the following expression returns the positions of the selected text in Area into the $First and $Last variables:
WR GET SELECTION(Area;$First;$Last)To select text in a 4D Write area, you need to reference characters. In most cases, you must first select text before using a command to manipulate it.
Product: 4D Write
Theme: 4D Write, Introduction to the language
4D Write Language ( 4D Write v15)
